Který materiál ozubených kol je nejlepší pro pohony harvestorů s vysokým točivým momentem?

Case-hardened alloy steels — typically 20CrMnTi, 20CrMo, or 17CrNiMo6 — are the dominant material for high-torque agricultural harvester gears worldwide. The carburising and quenching process produces a surface hardness of 58–62 HRC at the tooth flank and root, with a tough core remaining at 30–38 HRC below the hardened case. This combination resists pitting under high Hertz contact stress at the surface while the tough core absorbs the bending stress at the tooth root and the shock loads from harvesting operations. Case-hardened alloy steel is the correct choice for main drive gears, header drives, threshing cylinder drives, and any position where both surface fatigue and shock loading are present.

Through-hardened steels (42CrMo4, 40Cr, C45) are hardened uniformly through the cross-section to 32–45 HRC. This provides better tooth fracture resistance than case-hardened steel (the core is not soft) but lower contact fatigue resistance because the surface hardness is lower. Through-hardened steel is appropriate for moderate-speed, high-shock drives where fracture is the more likely failure mode than surface pitting — for example, crop lifter drives and certain feeder house applications that experience repeated rock and foreign object impacts. The lower surface hardness accepts some surface damage gracefully rather than fracturing, at the cost of earlier onset of pitting.

Gas nitriding produces a very hard, thin case (typically 0.2–0.5 mm deep) at 65–70 HRC on the tooth surface, with a moderate-strength core. The extremely hard surface provides excellent resistance to abrasive wear from contaminated environments — particularly relevant in harvesting applications where gearbox seals may allow some ingress of crop dust and fine soil. The shallow case depth limits the ability to absorb shock loads compared to deep-case carburised gears. Nitrided gears are well-suited to clean, high-speed drives in enclosed, well-sealed gearboxes but are not ideal for severely shock-loaded positions in harvesting equipment.

Grey and ductile cast iron gears are found in low-speed, low-torque positions in some agricultural equipment — certain metering drives, elevator chain sprockets, and similar applications. Cast iron’s vibration-damping properties and excellent machinability make it cost-effective in these positions. It is completely unsuitable for high-torque harvester drives because its brittle fracture behaviour under shock loading produces sudden tooth fracture without warning. Do not substitute cast iron for steel in any harvester drive position that experiences shock loading from crop material or foreign objects.